How To Use Spiral Screw Extractor Set

• Tools & Workshop

How To: Use a Screw Extractor

Have y'all ever just been zipping through a project only to run up against a cleaved screw or stripped screw head? No trouble! Option up a screw extractor, and you'll be picking up right where yous left off in no time.

Photo: istockphoto.com

At some betoken in the never-ending list of practise-it-yourself projects, nearly every handy homeowner encounters a stripped spiral—and this small obstacle can turn fifty-fifty the near straightforward home improvement project into a fatigued-out affair. Stripped screws ordinarily occur when you're dealing with worn or weathered fasteners, such equally those found on door hinges, cabinet hinges, and door strike plates. And, once you've managed to impairment or warp a screw head, it'south almost impossible to go that screw out with a common Phillips-caput or apartment-blade (slotted) screwdriver. Even worse, the odds of removing the screw decrease each fourth dimension the screwdriver slips in the slots. Enter a seasoned DIYer's go-to tool: a screw extractor.

While the specific blueprint of this cheap implement varies, it most commonly takes the form of a tapered drill chip with a reversed thread. When you lot put information technology to utilise, the extractor penetrates a hole punched or drilled in the summit of the screw and its reversed threads catch hold then that the spiral tin can be twisted out. A choice of screw extractors tin can exist found in most hardware stores—whether brick and mortar or online—bachelor in many different sizes to arrange a wide assortment of screw sizes. In one case you've snagged one every bit an immediate fix (and future repair tool), read on for the guidelines on how to use a screw extractor and relieve the twenty-four hours.

Tools & Materials

• Spiral extractor
• Condom glasses
• Center dial
• Hammer
• Drill bits
• Variable-speed reversible drill
• See full list «
• Thread cutting oil
• Penetrating oil
• Wrench

Step 1

Using a screw extractor entails drilling, striking, and cutting screws, all of which can potentially send small-scale shards of metal flying. To prevent middle injury, wear safety glasses.

Photo: istockphoto.com

Step two

Align the eye punch with the centre of the stripped or broken screw, and lightly strike it with a hammer. You want to create a small indentation in the center of the screw to help guide the drill scrap.

Step iii

Select a drill flake that is smaller in bore than the spiral or fastener, and secure it to the power drill. Apply a minor drop of thread cut oil to the head of the cleaved screw for easier drilling. If the stripped spiral is rusted or affixed to metallic, identify a small drop of penetrating oil on the threads to aid loosen its grip.

Step 4

Align the drill chip with the punched spot on the spiral head. Drill slowly and carefully, making certain to keep the drill and bit aligned direct with the spiral. Drill about 1/8 to one/4 inch into the screw head; the depth will depend on the size of the screw extractor you're using.

Step 5

Finally, insert the tip of your handy screw extractor into the bored pigsty. How to use a screw extractor will depend on the detail model yous've called, simply you'll likely employ either a wrench or drill to turn the tool counterclockwise. As you lot turn the screw extractor, its threads will draw it in until it bites into the hole. Once you experience the extractor take hold, go on turning counterclockwise and pull to completely remove the stripped or broken screw.

Source: https://www.bobvila.com/articles/how-to-use-a-screw-extractor/

Share this post